Take the 2-minute tour ×
English Language & Usage Stack Exchange is a question and answer site for linguists, etymologists, and serious English language enthusiasts. It's 100% free, no registration required.

I'm trying to find the correct noun for a u-shaped bend in an electrical component's pin. Is there a generic technical term that may usually refer to a deformation to reinforce e.g. an (angle) bracket made of sheet metal, where the 90° bend has been given a groove?

If you provided a few sentences using potential synonyms I would be grateful.

share|improve this question
1  
Is it like a score or scoring? Do you have a picture? I take it you aren't describing resistors/capacitors/LEDs. –  cornbread ninja 麵包忍者 Apr 4 '12 at 16:14
    
Yes, give more detail. Are you describing a connector pin, that would mate with a socket? Fluting is good, but maybe obscure to a techie. "A stiffening bend is used to keep the otherwise flat metal pin rigid for insertion." –  Bobbi Bennett Apr 4 '12 at 17:49
2  
It seems like what the title is asking about is completely different to what the description is asking for. The "J-Hook" on the end of a wire, used to "hook" around a connection post that helps hold it in place while being soldered or fastened with a nut, is completely different that the ribbing or fluting that provides extra rigidity in thin sheet metal parts. –  Jim Apr 4 '12 at 17:49
    
Jim has it right, the confusion is caused by the German word "Sicke", which seems to be used for both, the reinforcing bend e.g. in an angle bracket, and the formed leads of an electronics component. jwpat chose to ignore my description and answered the question in the "title" directly, giving me the information and an example that helps very much. Thank you all for contributing. –  none Apr 5 '12 at 15:46
add comment

2 Answers

For component leads, the rather generic terms lead forming and formed leads are often used. As an example, some thermistors are supplied with an offset jog referred to as formed leads. A second jog could give the U-shape you mention, which I think is somewhat as in first photo below. The other picture shows Excelta lead forming pliers. assembly with U's Lead forming pliers

Edit: Note that besides the dog leg bends mentioned in my answer two weeks ago, some related terms include inclined gull-wing, spider J-bend, and spider gull-wing lead designs for surface mount components, and omega bends and camel humps for surface mount quad packs and flat packs as in picture below.
camel hump

share|improve this answer
    
Is this for reinforcing the bend (what the OP is looking for)? Also, is this the same as 'crimping'? –  Mitch Apr 4 '12 at 21:03
    
No, lead forming mainly is relevant to the "u-shaped bend on electrical component's pin (wire) to aid in placement" portion of the question. Leads may be formed to fit required hole spacing, or to avoid dropping too far into a hole, or to provide some flex; but not reinforcing as far as I know. Also, crimping is different than forming; it is eg crushing a connector-pin's shell around a wire of a cable to make a tight connection. –  jwpat7 Apr 5 '12 at 6:00
add comment

Technically I think its dog leg, but very often referred to as a knee, which can be any forming that shows the depth of insertion of the lead to a hole or pad. Could also be referred to as a crimp in the leg.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.